Plug valves are valves with cylindrical or conically tapered "plugs" which can be rotated inside the valve body to control flow through the valve.

since the combustion mixture in a gasoline engine always burns at the same rate, as RPM goes up so does the amount you can advance the ignition timing. my question is, what is that rate of advance? i

We use gravity flow to transfer leachate (contaminated water) from a tank to an open pond on different elevations. Head difference, between the level in the tank and the dischage pipe end into pond,

I need some insight on specifically what happens at the plug when the gaps cannot be fired for any reason such as a very lean misture, excessive gap or a short.

Below are brief explanations for the common types of valves used in today's industrial flow control industry. To view diagrams of each valve type.

ASV RC60 and the bucket will randomly tilt down. If I slam the joystick back and fourth it

When installing plug valves, care should be taken to allow room for the operation of the handle, lever, or wrench. The manual operator is usually longer than the valve, and it rotates to a position pa

There is another o-ring seal under the rocker arm assembly. I did the same thing on my Honda just replaced the valve cover seals and oil still was getting into the spark plug tubes.